Westerbeke 15.0KW -60Hz EDT Návod k obsluze Strana 78

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 100
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 77
MAINTENANCE AND ADJUSTMENTS
Introduction
This section contains a scheduled maintenance program and several the
owner/operalor
can without
ihe
benefit
01
and tools and instruments.
Preventive
Maintenance
IEll0ilnel
Perform
ihe
preventive maintenance in accordance with the schedules listed in the paragraphs.
Adherence
to
these schedules will ensure the equipment
is
maintained in the best possible condition and
that it will perform
to
expectations. Those items marked by
an
asterisk (*) are recommended to be per-
formed
by
an
authorized dealer or distributor
Daily (belore each use)
1. Check the oil sump level, Maintain the oil level at
or
near the upper level mark on dipstick.
2.
Check the coolant level in the plastic recovery
tanK.
Maintain the coolant level halfway between the
MAX and ADD marks.
3.
Visually inspect the unit; check for loose bells, chafed or broken wires, loose brackets and fittings,
damaged hoses, loose clamps, and other equipment no! properly secured.
4.
Check the fuel supply.
Fililhe
tank(s) with a good grade
of
unleaded
or
leaded gasoline that has an
octane rating
of
89
or
better.
5.
Check the primary filter/water separator. Drain and service this IiIler as required.
(A
primary filter/water
separator
is
but strongly recommended. See page 41.)
6.
If an optional instrument panel
is
instailed, check the engine's gauges for proper
011
pressure, op,cral-
ternp,eralure,
and starling charging voltage once the engine
is
operating.
7,
II
AC
gauges are installed, check the generator's
quency.
Monthly
meters
for
proper
AC
voltage and fre-
Check the condition
of
the zinc anode
in
the heat exchanger's sea waler
circuit
Clean or replace the anode,
as Keep the area inside the heat exchanger
clean of zinc anode debris.
Se,·vicina
Aller
inilial
50
Hours
01
O~'Emilic)/1
1.
Change the "n,,,in,,'. lubrication oil and oillilte,-
2.
Clean or rer,lac:e the fuel filler screen in
tile
carburetor and in Ihe electric fuel iiI! pump.
3.
Rei·orcluelile
cyiiT,d'ar
head bolts.
Weslerbeke Generators
14
Zobrazit stránku 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 99 100

Komentáře k této Příručce

Žádné komentáře