search

Westerbeke 4.0Kw BCDB 50Hz Instalační manuál Strana 15

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 51
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
    •
  • KNIHY
    • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 14
GENERATOR
BREAK-IN
PROCEDURE
DESCRIPTION
Although your engine has experienced a minimum
of
one
hour
of
test operations at the factory to make sure accurate
assembly procedures were followed and that the engine
operated properly, a break-in time is required. The service
life
of
your engine is dependent upon how the engine is
operated and serviced during its initial hours
of
use.
Breaking-in a new engine basically involves seating the
piston rings to the cylinder walls. Excessive oil consumption
and smoky operation indicate that the cylinder walls are
scored, which is caused
by
overloading the generator during
the break-in period.
Your new engine requires approximately
50 hours
of
initial
conditioning operation to break in each moving part in order
to maximize the performance and service life
of
the engine.
Perform this conditioning carefully, keeping in mind the
following:
Start the engine according to the STARTING PROCEDURE
section. Run the engine while checking that all systems (raw
water pump, oil pressure, battery charging) are functioning.
AFTER
START-UP
Once the generator has been started, check for proper
operation and then encourage a fast warm-up. Run the gener-
ator between
20% and 60%
of
full load for the first 10 hours.
A
CAUTION:
00
not
attempt
to
break-in
your
generator
by
running
without
a
load.
After the first 10 hours
of
the generator's operation, the load
can be increased to the full-load rated output, then periodi-
cally vary the load.
Avoid overload at all times.
An
overload is signaled by
smoky exhaust with reduced output voltage and frequency.
Monitor the current being drawn from the generator and keep
it within the generator's rating.
Since the generator operates
at
1800 RPM to produce 60
hertz,
control
of
the generator's
break-in is governed
by
the current drawn from the generator.
CHECK
THE
FOLLOWING
D Monitor the control panel gauges.
D Check for leaks
of
fuel and engine oil.
D Check for abnormal noise such as knocking, friction,
vibration and blow-back sounds.
D Confirm exhaust smoke:
When the engine is cold - White
Smoke.
When the engine is warm - almost Smokeless.
When the engine is overloaded - some Black
Smoke.
To protect against unintentional overloading
of
the generator,
the generator's output leads should be routed through a circuit
breaker that is rated at the rated output
of
the generator.
NOTE:
Be aware
of
motor starting loads
and
the high current
draw required
for
starting motors. This starting amperage
draw can be
3 to 5 times normal running amperage. See
GENERATOR INFORMATION in this manual.
GENERATOR
ADJUSTMENTS
Once the generator has been placed in operation, there may
be adjustments required for engine speed (hertz) during the
engine's break-in period (first
50
hours) or after this period.
A no-load voltage adjustment may also be required in
conjunction with the engine's speed adjustment.
See
GENERATOR INFORMATION in this manual.
Engines & Generators
9
Zobrazit stránku 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Komentáře k této Příručce

Žádné komentáře
Související produkty a manuály pro Motor Westerbeke 4.0Kw BCDB 50Hz
Motor Westerbeke 63B Uživatelský manuál   (8 stránky)
Motor Westerbeke 14.0KW BTDCR Specifikace   (66 stránky)
Motor Westerbeke 38B FOUR Návod k obsluze   (108 stránky)
Motor Westerbeke 33a Uživatelský manuál   (33 stránky)
Motor Westerbeke 120D-TWO Servisní příručka   (59 stránky)
Motor Westerbeke 108B Instalační manuál   (62 stránky)
Motor Westerbeke 108B Instalační manuál   (60 stránky)
Motor Westerbeke WPDS-20 Návod k obsluze   (114 stránky)
Motor Westerbeke 33a Servisní příručka   (117 stránky)
Motor Westerbeke 120D-TWO Uživatelský manuál   (72 stránky)
Motor Westerbeke 12.0KW - 50Hz EDT Uživatelský manuál   (6 stránky)
Motor Westerbeke 21A Instalační manuál   (46 stránky)
Motor Westerbeke 108C SIX Uživatelský manuál   (12 stránky)
  • Audica ProLinx DKNY Belkin PSI Audio
  • Panasonic Kopírky Fujitsu Kopírky Magellan Dokovací reproduktory Invisio Mobilní headsety Denon Příslušenství k přehrávačům MP3 / MP4
  • Nokia C6-00 Sony CAS-1 AEG HG795550XB Cisco SG500-28-K9 Sony HDR-HC9E
  • Sony CDX-GT270MP Uživatelský manuál Alcatel Pixi Uživatelský manuál HealthRider Treadmill H90T Uživatelský manuál Parasound 275 Uživatelský manuál AEG L68470FL Uživatelský manuál