Westerbeke 120D-TWO Uživatelský manuál stáhnout pdf (Strana 13)

Adjustments and Settings

A030 - Cutting Table Calibration

Table of Contents

Installation

1. Turn the PLS on and lower the table all the way down to the bottom of its travel by

using the keypad or UCP.

23456789101112131415161718192021222324

2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

ENGRAVING TABLE

CUTTING TABLE

ADJUSTABLE MANIFOLD

2. Open the front door of the laser

system and carefully slide the cutting

table into the laser system so that its

body is squarely pushed up against

the engraving table rulers on the top

and the side of the table. The rulers

of the cutting table should now

overlap the rulers on the engraving

table.

3. After you have installed the Cutting Table into your PLS, manually focus to the

Cutting Table surface by using the appropriate focus tool.

4. Once that is complete, go directly to

your System Tab and you will notice

that the red CALIBRATE button for

the Cutting Table box will be

activated. Click on the CALIBRATE

button. A window will appear.

Accept the new Z-height BY clicking

on SAVE.

5. You are now done calibrating the new Z-height for engraving or cutting on the

Cutting Table.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 71 72

Žádné komentáře

Westerbeke 120D-TWO Uživatelský manuál Strana 13